SL L4-1.9L SOHC VIN 8 (1997)
10. Install the following electrical harness connectors and vacuum hoses.
a. Electrical connectors:
^
Idle Air Control (IAC).
^
Throttle Position (TP) Sensor.
^
Manifold Absolute Pressure (MAP) Sensor.
^
Fuel injectors (4).
^
EGR.
b. Vacuum Hoses:
^
EVAP Cannister purge solenoid.
11. Install PCV valve hose.
12. Install air inlet tube, connecting fresh air hose at cam cover.
13. Connect negative battery terminal.
14. With engine off and ignition on, pressurize the fuel system and check for fuel leaks.
15. Install cylinder block drain plugs and close radiator drain. Torque to 35 Nm (26 ft. lbs).
16. Fill with coolant. Use only a non-phosphate ethylene glycol-based antifreeze.
NOTE: Vehicle must be level when filling coolant.
17. Prime fuel system.
a. Cycle ignition on for five seconds and then off for 10 seconds.
b. Repeat step 17a twice.
c. Crank engine until it starts (maximum starter motor cranking time is 20 seconds).
d. If engine does not start, repeat steps 17a-17c.
18. Start engine and check for leaks.
19. Fill the cooling system surge bottle to the cold full line. Check coolant level after the engine has run for two to three minutes.
