SL L4-1.9L SOHC VIN 8 (1997)
CAUTION: WHEN YOU ARE DEPLOYING AN INFLATOR MODULE FOR DISPOSAL, PERFORM THE DEPLOYMENT
PROCEDURES IN THE ORDER LISTED BELOW
-
WEAR SAFETY GLASSES THROUGHOUT THE PROCEDURES.
-
CLEAR A SPACE ON THE GROUND ABOUT 1.8S METERS (SIX FEET) IN DIAMETER WHERE THE INFLATOR MODULE
WILL BE DEPLOYED.
-
MAKE SURE THE AREA AROUND THE INFLATOR MODULE IS CLEAR OF ALL PEOPLE AND LOOSE OR FLAMMABLE
OBJECTS.
-
SHORT THE DEPLOYMENT HARNESS WIRES AS INSTRUCTED.
-
CONNECT THE DEPLOYMENT HARNESS TO THE INFLATOR MODULE BEFORE YOU CONNECT IT TO THE POWER
SOURCE.
-
CONNECT THE DEPLOYMENT HARNESS TO THE POWER SOURCE TO IMMEDIATELY DEPLOY THE AIR BAG.
FAILURE TO FOLLOW THE PROCEDURES IN THE ORDER LISTED MAY RESULT IN PERSONAL INJURY
Procedures for deployment of a live (undeployed) inflator module within the vehicle are as follows:
1. Lower driver and passenger windows. Turn ignition switch "Off."
2. Check that the driver inflator module is secured to the steering wheel and that the passenger inflator module is secured to the instrument panel.
3. Remove all loose objects from front seat and inflator module covers
4. Disable the SIR System. (Refer to "Air Bag(s) Arming and Disarming.")
5. Cut the two wires of each yellow two-way connector away from the vehicle harness leaving at least 150 mm (6 in.) of wire at the connector.
6. Strip 15 mm (1/2 in.) of insulation off both leads from the connector.
