SL L4-1.9L SOHC VIN 8 (1997)
6.
Using Tie Rod Separator SA91100C (or equivalent), remove tie rod end from steering knuckle.
7.
Repeat steps 4 through 6 to remove tie rod end from steering knuckle on other side of vehicle.
IMPORTANT:
Remove front section of splash shield first, then rear section of splash shield.
8.
Remove left side splash shield.
a. Remove two push pins.
IMPORTANT:
If molded-in fasteners are damaged or broken, drill out with a 5/16 bit and replace with a push pin.
b. Remove lower shield to cradle molded-in fasteners at cradle by gently prying at three fastener locations and remove splash shield.
9.
Loosen intermediate steering shaft cover from steering gear assembly and move up enough to access pinch bolt.
10.
Remove pinch bolt.
NOTICE:
After pinch bolt is removed, do not allow steering wheel or intermediate shaft to rotate, or SIR coil assembly could be damaged.
