SL L4-1.9L SOHC VIN 8 (1997)
16.
Install intermediate shaft onto the steering gear assembly and torque pinch bolt.
Torque: 47 N.m (35 ft-lbs)
17.
Position intermediate steering shaft cover over steering gear assembly.
IMPORTANT:
Install rear section of splash shield first, then front section of splash shield.
18.
Install left side splash shield.
19.
Install tabs in body cut-out.
IMPORTANT:
Make sure shield flaps are tucked in at body locations.
20.
Align molded-in shield fasteners with holes in cradle. Push straight in to install.
21.
Install push pins.
IMPORTANT:
Tie rod end stud threads must be thoroughly cleaned and lubricated before tightening tie rod end-to-steering knuckle castle nut. Lubricate only the
thread part of the stud. Do not lubricate the smooth tapered portion of stud.
