SL L4-1.9L SOHC VIN 8 (1997)
4. Install flywheel housing dust cover with three bolts.
-
Torque: 11 N.m (97 inch lbs.).
5. Install powertrain stiffening bracket and install bracket to engine, and bracket to transaxle bolts.
-
Torque: 54 N.m (40 ft. lbs.).
NOTICE: Use caution not to damage axle seal when intermediate shaft is installed into transaxle.
6. Install axle seal protector tool SA91112T inside seal. (Left side shown, right side similar.)
7. Install intermediate shaft into transaxle.
8. After splines clear the seal protector but before snapping the axle into place, remove the seal protector tool.
9. Position intermediate shaft support and install two bolts.
-
Torque: 54 N.m (40 ft. lbs.).
10. Install intake bracket to intermediate shaft support bolt.
-
Torque: 54 N.m (40 ft. lbs.).
