SL L4-1.9L SOHC VIN 9 (1991)
6.
At division post of rear door stationary window, gently pull outer door panel outboard approximately 35 mm (1.38 inches) and remove lower
stationary window fastener.
7.
Remove rear half of glass run weatherstrip.
8.
Remove stationary window by pulling upper tip toward front of vehicle, followed by the bottom. Once rear of stationary window is out of rear
window frame, tilt outboard and pull up removing window from vehicle.
9.
Remove inner sealing strip.
10.
Partially remove inner door trim panel at top.
11.
Remove foam filler at rear of door at belt.
12.
Using an 8 inch flat bladed screwdriver, place tip of blade at location on side door latch assembly as shown.
13.
Tap screwdriver downward, piercing through plastic housing. This will cause side door latch assembly to release, allowing the door to open.
14.
Install foam filler at rear of door at belt.
15.
Replace stationary window according to procedures in the "Doors" section of the "Body/Collision Repair Service Manual." Disregard step 5 of the
service manual installation procedure.
16.
Install inner door trim panel at the top.
17.
Install inner sealing strip.
18.
Replace damaged side door latch assembly according to procedures in the "Doors" section of the "Body/Collision Repair" Service Manual."
PARTS REQUIREMENTS:
CLAIM INFORMATION:
