SL L4-1.9L SOHC VIN 9 (1991)
4.
Seal mirror patch to door by applying strips of strip caulk such as 3M Strip Caulk # 08578 (or equivalent) to the mirror patch gasket. Apply one
strip to the rear of the gasket and two strips to the bottom of the gasket, as shown in the Figure.
IMPORTANT:
Thickness of strip caulk should not be greater than 2 mm (0.080 inch).
5.
Install a piece of 1/4 x 5/32 inch foam tape such as Kent Industries # 40105 (or equivalent) to rear edge of mirror.
6.
Install outside rearview mirror. Refer to "Outside Mirror" installation procedures in the "Doors" section of the "Body Service Manual."
