SL L4-1.9L SOHC VIN 9 (1991)
Wheel Speed Sensor: Service and Repair
Front
Fig. 64 Front Speed Sensor Replacement
1.
Disconnect battery ground cable, then raise and support vehicle.
2.
Disconnect wheel speed sensor electrical connector, Fig. 64.
3.
Remove wheel speed sensor to steering knuckle Torx head bolt, then the wheel speed sensor. When removing speed sensor be careful not to
damage speed sensor ring. Even a minor scratch on the sensor ring can cause a loss of ABS operation. The front speed sensor has a
locating pin which may become stuck in the steering knuckle. This pin may separate from sensor during removal and remain in the
knuckle. If this pin cannot be pulled out of the knuckle it must be drilled out using an 8mm drill bit. Be careful not to enlarge the pin hole
when drilling pin out of knuckle.
4.
Reverse procedure to install. Torque Torx head bolt to 89 inch lbs.
Rear
Fig. 65 Rear Hub & Bearing Assembly Replacement
1.
Disconnect battery ground cable, then raise and support vehicle.
2.
Remove tire and wheel assembly, then disconnect electrical connector from speed sensor.
3.
Remove two caliper to knuckle mounting bolts, then suspend caliper with wire to strut spring.
4.
Remove rotor from hub, then the four hub to knuckle attaching bolts, Fig. 65.
5.
Remove hub and bearing assembly.
6.
Reverse procedure to install, torque hub to knuckle bolts and caliper to knuckle bolts to 63 ft. lbs.
