SL L4-1.9L SOHC VIN 9 (1991)
2.
Remove blower motor mounting screws and remove blower motor assembly.
3.
Check the HVAC module for debris through the blower motor opening. Remove any debris from evaporator case.
IMPORTANT:
Use care when removing debris from front of evaporator to prevent damage to the evaporator fins.
4.
Install blower motor and connect electrical connector.
5.
Check right-side, air inlet at cowl for presence of upper cowl barrier foam ring (P/N 21030702). If it is present, remove from vehicle.
a.
Use plastic scraper to remove foam ring.
b.
Use 3M(R) General Purpose Adhesive Cleaner P/N 051135-08989 (or equivalent) to clean off adhesive.
c.
Check if black adhesive tape (nose patch), shown in Figure 3 that was installed on early 1991 vehicles is present. If present, remove from
vehicle.
d.
Apply 3M(R) Electrical Moisture Sealant P/N 06149 (or equivalent) over 10 mm tooling hole.
NOTE:
