SL L4-1.9L SOHC VIN 9 (1991)
c.
Route through conduit on I/P harness at left side bracket of HVAC module.
d.
Reaching through radio opening, pull wire rearward, and spot tape to radio harness.
e.
Route wire downward, forward of I/P carrier radio support bracket.
f.
Follow HVAC module harness branch downward, then rearward to IPJB connector.
25.3 Splice wire to WHT wire from delayed blower motor control module and spot tape to HVAC module harness.
26.
The BLU wire from the delayed blower motor control module is unused. Tape end of BLU wire and tape back to jumper harness of delayed
blower motor control module. The delayed blower motor control module GRN wire is used for testing.
27.
Attach top half of "Notice" label provided in kit to blower motor cover. Attach bottom half of "Notice" label to inside of right side console
extension assembly.
28.
Connect IPJB black 46-way connector to IPJB.
Torque:
IPJB Connector to IPJB: 6.5 N.m (58 in-lbs)
29.
Connect negative battery cable.
Torque:
Battery Cable: 17 N.m (13 ft4bs)
IMPORTANT:
Do not install parts that have been removed, except for black 46-way connector, until correct operation of the delayed blower motor control module
has been verified.
30.
Proceed to "Testing the Delayed Blower Motor Control Module" and verify operation. After operation is verified, proceed to next step.
31.
Disconnect negative battery cable.
32.
Install console. (Refer to "Console" installation procedure in the "Instrument Panel and Console" section of the "1991 - 1994 Body/Collision
Service Manual.")
33.
Install radio. (Refer to "Radio" installation procedure in the "Instrument Panel and Console" section of the "1991 - 1994 Body/Collision Service
Manual.")
34.
Insert I/P upper trim panel by inserting into clips at windshield and snapping rear of I/P upper trim panel into position.