SL L4-1.9L SOHC VIN 9 (1991)
Evaporative Emission Control Canister: Service and Repair
VAPOR CANISTER AND BRACKET ASSEMBLY REPLACEMENT
Removal Of Cover To Access Evaporative Cannister.
Evaporative Cannister Removal.
REMOVAL
1.
Position vehicle on hoist.
2.
Disconnect negative battery cable.
3.
Loosen right wheel lug nuts.
4.
Raise vehicle to a comfortable working position.
5.
Remove right front wheel and tire.
6.
Remove inner wheel liner fasteners at front corner using screwdriver.
7.
Carefully pull panel downward to gain access to vapor canister and bracket fasteners.
8.
Disconnect vapor line hoses.
9.
Remove canister bracket assembly fasteners.
10.
Remove vapor canister from bracket.
INSTALLATION
WARNING: PINCHED, KINKED OR DAMAGED VAPOR LINES MUST BE REPLACED.
1.
Install vapor canister in bracket assembly with ports correctly positioned. Do not tighten fastener until canister and bracket have been installed and
canister is properly positioned. Inspect vapor lines for kinks, bends or damage during installation.
2.
Install canister bracket assembly and fasteners.
^ Torque: 30 Nm (22 ft lbs)
CAUTION: The vapor canister can be damaged if the band clamp bolt is over torqued.
3.
Position canister and torque fastener.
