saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Keyless Entry/Security System - Information|Page 12 > < Keyless Entry/Security System - Information|Page 10
Page 3
background image

Not flashing:
72 hours have elapsed since the ignition was turned Off or the ignition is On (key in RUN position).

NOTICE:
LED will also stop flashing if the system has completed a full two minute alarm cycle.

Horn

The horn is activated by the security system as follows:

One chirp:
System has just been armed (actively or passively).

Two chirps:
System has just been disarmed with the transmitter (actively).

Two chirps followed by one chirp:
System has just been disarmed with the transmitter (actively) and the LED is flashing to indicate history. (Refer to History Feature in Owner's Manual.)

Short tones:
System is in escalating alarm. Occurs prior to the full-alarm cycle.

Long tones:
System is in the full-alarm cycle.

Dome Lamp (Up-Level System)

The dome lamp is controlled by the security system to provide an additional 30 seconds of illumination upon exiting the vehicle. Upon returning to the
vehicle and disarming the system or unlocking the doors with the transmitter, the dome lamp is also turned On.

Parking Lamps (Up-Level System)

The parking lamps are activated by the security system as follows:

One flash:
System has just been armed (passively or actively).

Two flashes:
System has just been disarmed with the transmitter (actively).

Two flashes followed by one flash:
System has just been disarmed with the transmitter (actively) and the LED is flashing to indicate history. (Refer to History Feature in Owner's Manual.)

Continuous flashing:
System is in the alarm cycle. Continuous flash will also occur if the system has had a power interruption (battery low) indicating that it is ready for
transmitter programming.

Door Jamb Switches

The security system monitors the door jamb switches as follows:

^

If the system is armed (actively) and a door is opened, the system will enter the escalating alarm cycle followed by a full-alarm cycle.

^

If the system is armed (passively) and a door is opened, the system will count down 17 seconds and if the key is not turned to the RUN position, or if
the system is not disarmed with the transmitter, a full alarm cycle will begin.

^

After the ignition is turned Off, the last door is closed and the valet switch is in the ON or SHOCK OFF position, the system will passively arm after
approximately 25 seconds.

Power Door Lock Relay and Actuators
(Up-Level System)

On vehicles equipped with power door locks, the security system supplies voltage to the power door lock relay to energize the power door lock actuators.
The power door locks are controlled as follows:

Keyless Entry/Security System - Information|Page 12 > < Keyless Entry/Security System - Information|Page 10