SL L4-1.9L SOHC VIN 9 (1991)
6.
Move 5th/Reverse fork and synchronizer sleeve to engage 5th gear to lock transaxle into two gears at the same time.
7.
Install shaft nut and torque.
IMPORTANT:
Make sure that the threads on the shaft are clean and free of oil. A wire brush may be used to clean the threads of the shaft.
Torque:
150 N-m (110 lbs.ft.)
8.
Unlock the shafts by moving 5th fork to the neutral gate.
9.
Install the 5th/Reverse fork retaining rings using P/N 21120014. Two retainers are required.
10.
Turn the reverse cone so one of the slots is facing the top of the transaxle (align cone to rear cover).
11.
Install rear cover gasket.
NOTICE:
Clean and lubricate fasteners with ATF (DEXRON(R)-II or equivalent) wipe. off excess fluid and install.
12.
Install rear cover and install bolts and torque using a crisscross pattern.
Torque:
14 N-m (124 lbs.in.)
13.
Install inner splash shield.
NOTICE:
Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause wheel
lug nuts to loosen in service.
14.
Position wheel onto hub.
15.
Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to be sure torque is correct.
Torque:
140 N-m (103 lbs.ft.)
16.
Fill transaxle with fluid.
Parts Requirements:
PARTS
REQUIREMENTS:
21001360 1-Housing Asm-Shift Cont
