SL L4-1.9L SOHC VIN 9 (1991)
9. Install outer sealing strip by aligning location tab at rear of sealing strip with slot in door panel. Working from the rear forward, push seal strip
down on to flange until fully seated.
10. Check seal on mirror assembly for proper location and install mirror assembly to door, install nuts and tighten.
Torque: 6 Nm (53 in.lbs.)
11. If passenger side power mirror connect harness connector and install connector position assurance (CPA) device.
12. Install foam filler in mirror patch area.
13. On driver side, install mirror cable into trim panel and tighten set screw.
Torque: 3 Nm (27 in.lbs.)
