SL2 L4-1.9L DOHC VIN 7 (1997)
7. Remove left side splash shield.
a. Remove two push pins.
b. Remove lower shield to cradle molded-in fasteners at cradle by gently prying at three fastener locations.
IMPORTANT: Remove front section of shield first, then rear.
IMPORTANT: If molded-in fasteners are damaged or broken, drill out with a 5/16 bit and replace with a push pin.
8. Loosen intermediate shaft cover from steering gear and move up enough to access pinch bolt.
9. Remove pinch bolt.
10. Place an approved drain container under pressure and return hoses at steering gear.
11. Remove power steering pump pressure and return hoses from steering gear and allow system to drain.
