SL2 L4-1.9L DOHC VIN 7 (1997)
7. Remove front inner fender splash shield.
a. Remove two push pins.
b. Remove lower shield to cradle molded-in fasteners at cradle by gently prying at three fastener locations.
LEFT SIDE
^
Remove front section of shield first, then rear.
RIGHT SIDE
^
Remove rear section of shield first, then front.
IMPORTANT: If molded-in fasteners are damaged or broken, drill out with a 5/16 bit and replace with a push pin.
8. Remove the lower control arm-to-cradle fastener.
9. Remove tension strut nut at lower control arm.
10. Remove lower control arm from vehicle.
INSTALLATION
