SW L4-1.9L DOHC VIN 7 (1993)
Drive Belt Tensioner: Service and Repair
Fig. 35 Belt Tensioner Removal
Tensioner internal components are nor serviceable, do not disassemble tensioner.
1.
Disconnect battery ground cable.
2.
Remove belt as outlined under BELT.
3.
Remove power steering pump with bracket.
4.
Remove tensioner upper and lower attaching bolts, Fig. 35.
5.
Install suitable pry bar between steel engine mount and steel frame rail, then move engine slightly toward drivers fender, as required, then remove
tensioner.
6.
Reverse procedure to install.
