SW L4-1.9L DOHC VIN 7 (1993)
sprockets must be correct to make sure the engine is properly timed.
g. Install the fixed guide.
Torque: 28 Nm (21 ft lbs).
IMPORTANT: The timing chain should be snug against the fixed guide.
h. Install the pivoting chain guide. Check for clearance between the block and head. Torque the bolt and make sure the guide pivots freely.
Torque: 26 Nm (19 ft lbs).
NOTICE: The camshafts must be positioned fully forward prior to bearing cap installation.
i.
Install the two forward remaining camshaft bearing caps and timing chain guide.
Torque: 14 Nm (124 in lbs).
j.
Retract the tensioner plunger and pin the ratchet lever using a 3.18 mm (1/8 in. or No.31) drill. Install the chain tension and torque the two
bolts. Remove the drill and allow the tensioner plunger to extend.
Torque: 19 Nm (168 in lbs).
k. Verify all timing marks for accuracy. Remove the camshaft timing pins.
