SW L4-1.9L DOHC VIN 7 (1993)
15.
Using black electrical tape, solid wrap 381 mm (15 in.) of the delayed blower motor control module jumper harness, starting at electrical
connector end.
16.
Connect delayed blower motor control module jumper harness with delayed blower motor control module pigtail at heater duct.
17.
Route delayed blower motor control module jumper harness under front heater duct, forward of rear heater duct (if equipped), to the I/P wiring
harness on the driver's side of the vehicle.
18.
Remove radio. Refer to "Radio" removal procedure in the "Instrument Panel and Console" section of the "1991 - 1994 Body/Collision Service
Manual.")
19.
Remove console. (Refer to "Console" removal procedure in the "Instrument Panel and Console" section of the "1991 - 1994 Body/Collision
Service Manual.")
20.
Disconnect instrument panel junction block (IPJB) black 46-way connector and pull it rearward through H-brace and towards driver's side of
vehicle.
NOTICE:
To prevent any possibility of a short circuit, replace any tape that is pushed back or removed from any wiring harness that is moved.
21.
Route delayed blower motor control module's jumper harness rearward through H-brace.
IMPORTANT:
For information on splicing wires, refer to "Wire Splicing" instructions in this bulletin.
