SW L4-1.9L DOHC VIN 7 (1993)
Fuel Gauge Sender: Service and Repair
Removal Of Sender From Fuel Pump Module.
Removal Of Sender From Fuel Pump Module.
REMOVAL
WARNING:
^
Do not allow smoking or the use of open flames in the area where work on the fuel system is taking place.
^
Anytime the fuel system is being worked on, disconnect the negative battery cable, except for those tests where battery voltage is
required.
1. Remove fuel tank, refer to Fuel Tank / Service and Repair.
2. Remove fuel pump module, refer to Fuel Tank Unit / Service and Repair.
3. Remove the two sending unit electrical connections with needle nose pliers or by pressing down the locking tab and pulling connector off the
terminal.
3. Using a 1/4 inch flat tip screwdriver, push in on the sender assembly attachment tang and lift up on the sender.
NOTE: The fuel pump assembly is only serviced as a module without the sender unit. The filter can be cleaned with mineral spirits, however, it
cannot be replaced. The fuel pump module to tank O-ring must always be replaced whenever the module is removed from the fuel tank.