SW L4-1.9L DOHC VIN 7 (1993)
Temperature Sensor (Gauge): Testing and Inspection
Use the following chart to obtain the proper resistance to produce the desired gauge reading. Engine off, key on. Dial up the resistance on the
potentiometer using a Digital Multimeter on the ohms setting. Disconnect the wire harness from the coolant temperature indicator sensor (located on the
upper front left side of the engine). Clip one lead from the potentiometer to the Dark Green/Yellow wire using a diagnostic probe device. Clip the other
lead from the potentiometer to a good engine ground,
Check the resistance through the sensor to ground at the connector pin.
Sensor Resistances: 24°C (75°F) 2200 - 2900 ohms
