SW L4-1.9L DOHC VIN 7 (1993)
INSTALLATION
1. Install switch to transaxle and install switch to case bolts. Do not tighten bolts at this time.
2. Install manual lever-to-control shaft and install nut.
NOTICE: Once lever is installed. Do not rotate with excessive force as switch could be damaged.
Torque: 12 Nm (106 in lbs)
ADJUSTMENT
1. Place transaxle in D (Drive). Use ohmmeter or continuity tester to check for continuity across terminals on selector switch if no continuity is
present rotate switch to achieve continuity.
2. Tighten switch to case bolts. After switch to case bolts have been tightened check continuity.
Torque: 14 Nm (124 in lbs)
3. Install cable to control lever and adjust cable.
4. Connect electrical connectors.
5. Install air filter box.
Torque: 10 Nm (89 in lbs)
6. Install air induction tube and tighten clamps.
Torque: 2 Nm (18 in lbs)
