SW L4-1.9L DOHC VIN 7 (1993)
Steering Gear: Service and Repair
Manual Steering Gear
1.
Disconnect battery ground cable.
2.
Raise and support vehicle.
3.
Remove front wheel assemblies.
4.
Remove and discard tie rod end cotter pins.
5.
Using tool No. SA91100C or equivalent, remove tie rod end from steering knuckle. Do not separate joint with wedge type tool or damage may
result.
6.
Remove left inner fender splash shield.
7.
Loosen intermediate shaft cover from steering gear, then raise slightly, remove pinch bolt.
8.
Remove steering gear cradle attaching bolts, then remove through left fenderwell.
9.
Reverse procedure to install.
