SW L4-1.9L DOHC VIN 7 (1993)
Stabilizer Bar: Service and Repair
Fig. 2 Brake Line Removal
1.
Raise and support vehicle, then remove wheel assembly.
2.
Position suitable container at left rear brake line, then disconnect and plug left brake line.
3.
Remove right and left stabilizer bar link to knuckle attaching nuts, then bar to crossmember nuts.
4.
Loosen but do not remove lateral link to knuckle attaching bolts, the remove trailing arm to knuckle and arm to body attaching nuts.
5.
Slide trailing arm from knuckle, then remove lateral link bolt, swing link downward.
6.
Disconnect brake lines from crossmember, Fig. 2.
7.
Remove stabilizer bar.
8.
Reverse procedure to install.
