SW L4-1.9L DOHC VIN 7 (1993)
Battery Tray Removal
Transaxle Connectors
Valve body Cover
1. Orient the manual valve to the manual link with the flat or notch on the manual valve facing up.
IMPORTANT: There was a change to the manual valve links in 1994. The link changes from a stamped form to a one piece wire form link. The
end of the link that attaches to the manual valve was also made thicker. Care should be used to ensure that the correct link is used. The two links
are not interchangeable.
2. Lower valve body and insert manual link into manual valve.
IMPORTANT: The valve body-to-case bolts must be placed in the valve body prior to installation.
3. Install and finger tighten valve body-to-case bolts first. This procedure must be followed to assure valve body is properly aligned to the case.
NOTICE: Clean and lubricate fasteners with ATF fluid. Wipe off excess fluid and install.