SW L4-1.9L DOHC VIN 7 (1993)
8. Apply heat using butane torch (included with special tool SA9138Z), heating to 175°C (347°F), working from the center to the ends, until glue flows
around both edges of crimp and seal sleeve.
CAUTION:
DO NOT USE MATCH OR OPEN FLAME TO APPLY HEAT TO SEAL.
9. Install a 64 mm (2.5 in.) length of flexible conduit (P/N 21023494) over harness. Place flexible conduit so that there is an approximate 6.35 mm (1/4
in.) gap between the end of the flexible conduit and the park neutral position switch assembly wiring connector.
10. Tape flexible conduit with electrical tape at both ends to secure flexible conduit in place.
11. Connect park neutral position switch assembly electrical connector.
12. Install front air intake duct assembly and air hose.
13. Verify condition has been repaired.
PARTS REQUIREMENTS:
21023494
Flexible Conduit
12029189
Crimp and Seal Sleeve Splice (Salmon)
Available from OTC Division of SPX Corporation at 1(800) 533-5338, or from Packard Electric at 1 800-PACKARD (with a minimum
CLAIM INFORMATION:
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System as follows:
Labor
Case
Operation
Type
Description
Code
VW
Repair Park Neutral Position N6045
Switch Wiring and Install
Flexible Conduit