SW L4-1.9L DOHC VIN 7 (1993)
Shift Cable: Service and Repair
Installation
SHIFT SELECTOR CABLE
INSTALLATION
IMPORTANT: All service replacement shift cables will have the bolt in type pass through grommet. The bolt in type cable pass-through grommet is
installed from the inside of the vehicle.
1. For 1991, 1992 and early 1993 vehicles, perform the following steps:
a. Separate and fold back sound deadener from front of dash.
b. Place cables and retaining plate through front of dash and push grommet into opening being sure to properly align grommet pilot into front of
dash.
IMPORTANT: When removing and installing shift cables, it is helpful to have a second person inside the vehicle to guide the cables and
prevent them from being tangled.
c. Raise vehicle.
IMPORTANT: Make sure insulation material does not become trapped between grommet and front of dash.
d. Place retaining plate on studs and install nuts.
Torque: 6 Nm (53 inch lbs.)
2. For late production 1993 and 1994 vehicles, perform the following steps:
a. Raise vehicle.
IMPORTANT: All service replacement shift cables will have the bolt in type pass through grommet.
IMPORTANT: The snap in type cable pass-through grommet is installed from the outside of the vehicle.
b. Guide cables through cable pass-through hole in floor pan.
IMPORTANT: When removing and installing shift cables, it is helpful to have a second person inside the vehicle to guide the cables and
prevent them from being tangled.
c. Insert the cable pass-through grommet into the cable pass-through hole in the floor pan, engaging the passenger side of the grommet first. Snap
the driver's side of the grommet into place by pressing inward and toward the passenger side of the vehicle.
3. Lower vehicle.
NOTICE: Do not drag boot through bracket hole as boot damage may occur.
4. Insert cables into clutch housing and install retainers. Use care not to kink cables and be sure cables arc not crossed.
IMPORTANT: The knurled edge on the shift cable must face up.
