SW L4-1.9L DOHC VIN 7 (1993)
9. Remove door panel screws and remove door panel by pulling front out, rear out, and then move entire panel rearward.
10. If damaged, remove foam seal strips from perimeter of door structure.
11. If damaged, remove foam tape fillers at the front edge of outer door panel.
12. If replacing panel:
a. On 1991 and 1992 vehicles, remove rivets by pushing mandrel out with punch and remove outer door panel lower sealing strip.
b. Remove door lock cylinder bezel compressing retainer tabs and pushing out.
c. Remove J-clips.
d. Remove trim molding and clip.
INSTALLATION
1. If replacing panel:
a. Install clip and trim molding.
b. Install J-clips.
c. Install door lock cylinder bezel.
d. Install outer door panel lower sealing strip with rivets.
