SW2 L4-1.9L DOHC VIN 7 (1997)
c. Connect bar hooks to engine support brackets.
d. Position stabilizer foot on engine block to the right of the engine oil dipstick.
e. Adjust hooks and stabilizer to remove looseness.
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST. TO HELP
AVOID PERSONAL INJURY, PROVIDE ADDITIONAL SUPPORT TO THE OPPOSITE END OF THE VEHICLE THAT
COMPONENTS WILL BE REMOVED FROM.
10. Raise vehicle on hoist.
11. Remove front road wheels.
12. Remove left and right side splash shields.
a. Remove two push pins.
b. Remove lower shield to cradle molded-in fasteners at cradle by gently prying at three fastener locations.
IMPORTANT: For left side, remove front section of shield first, then rear. For right side, remove rear section of shield first, then front
IMPORTANT: If molded-in fasteners are damaged or broken, drill out with a 5/16 bit and replace with a push pin.
