saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Sunroof / Moonroof Weatherstrip > < Sunroof / Moonroof Module|Diagrams|Page 11066
Page 3
background image

7. Connect four sunroof drain hoses to the sunroof module. Make sure hoses are not kinked.

8. Adjust sunroof glass to 1 mm (0.040 in.) below roof surface at front and 1 mm (0.040 in.) above roof surface at rear by loosening sunroof glass

attaching screws and moving sunroof glass.

Torque: 3 Nm (26 in-lbs)

9. Install headliner. Refer to "Headliner Installation" procedure.

SUNROOF MODULE ALIGNMENT

1. Remove headliner. Refer to "Headliner Removal" procedure.

2. Loosen sunroof module fasteners.

3. Align sunroof module by cycling glass open and closed. In the closed position, the glass will center the module.

4. With glass fully closed, tighten sunroof module fasteners.

Torque: 14 N.m (124 in-lbs)

5. Install headliner. Refer to "Headliner Installation" procedure.

Sunroof / Moonroof Weatherstrip > < Sunroof / Moonroof Module|Diagrams|Page 11066