SW2 L4-1.9L DOHC VIN 7 (1997)
a. Place wrench over bleeder valve.
b. Attach transparent hose over bleeder valve nipple. Submerge other end of hose in a transparent container of brake fluid.
c. Loosen bleeder screw.
d. Apply brake pedal slowly and hold.
e. Tighten bleeder valve.
^
Torque front bleeders to 11 Nm (97 inch lbs.)
^
Torque rear bleeders to 7.5 Nm (66 inch lbs.)
f.
Release brake pedal.
g. Repeat sequence until all air is removed from brake lines.
9. If more than one brake line is being bled, bleed in the following sequence:
a. Right rear
b. Left front
c. Left rear
d. Right front
10. Check brake pedal feel for sponginess. If brake pedal exhibits this feel, repeat bleeding procedure until condition disappears.
11. When bleeding procedure is completed on each wheel, check the reservoir fluid level. Fill as necessary.
Manual Bleeding
