SW2 L4-1.9L DOHC VIN 7 (1997)
9. Rotate brake hose so that it loops to the rear and connect brake hose to caliper with new washers.
^
Torque to 49 Nm (36 ft. lbs.)
10. Bleed brakes. See: Hydraulic System/Service and Repair
CAUTION: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel lug nuts to loosen in service.
11. Position wheel onto hub.
12. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to be sure torque is correct.
^
Torque to 140 Nm (103 ft. lbs.)
13. Lower vehicle from hoist.
