SW2 L4-1.9L DOHC VIN 7 (1997)
firmly by tightening clamp screw.
14. Select appropriate OP. 1 (operation 1) punch by rotating punch turret until the correct size (4.75 mm DIN) points towards the open end of the pipe
to be flared.
15. Pull the operating handle against the resistance of the pipe to create the flare and return handle to original position.
16. Release clamp screw and rotate locking plate to the open position.
17. Remove the die set and pipe and separate by gently tapping both halves on a bench.
18. Inspect pipe flare for correct shape, size and any flaws.
19. Repeat procedure (steps 6 through 18) for pipe being repaired.
20. Bend pipe using an approved pipe bending tool such as 5A91 1O8NE (or equivalent), using the section to be replaced as a guide.
21. Install new pipe to pipe being repaired using female union.
