SW2 L4-1.9L DOHC VIN 7 (1997)
11. Measure outside diameter of brake shoes and adjust brake adjuster to obtain 0.50 mm (0.020 inch) less than the reading obtained in step 10.
12. Install brake drum.
13. Install trailing arm/park brake cable fasteners to body.
^
Torque to 120 Nm (89 ft. lbs.)
14. Install park brake grommet/cable assembly onto floor pan.
15. Install park brake cable retaining tie strap.
CAUTION: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake drums. Failure to do so can cause wheel
lug nuts to loosen in service.
16. Position wheel onto hub.
17. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to be sure torque is correct.
^
Torque to 140 Nm (103 ft. lbs.)
18. Lower vehicle from hoist.
19. Route the cable under carpeting and install park brake cable into the park brake base. Push carpeting back to its original position.
