SW2 L4-1.9L DOHC VIN 7 (1997)
8. Install left and right lower trim panel extensions by inserting hinges into console openings. Then rotate closed and push in at dual lock locations.
9. Install I/P lower closeout panel by inserting bottom clip into module heater duct and rotating upward to snap in top clip.
WARNING: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED. TO HELP AVOID PERSONAL
INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END
FROM WHICH COMPONENTS ARE BEING REMOVED.
10. Raise vehicle.
CAUTION: Be careful not to push hoses onto heater core so far that foam seal is unseated.
11. Install hose and clamp on heater core outlet. Position clamp at a 7-8 o'clock position.
