SW2 L4-1.9L DOHC VIN 7 (1997)
Wire Size Gage
3. Determine proper sleeve for gage wire from the above chart.
4. Position stripped ends in sleeve until wires hit the top in the center of the splice.
5. Hand crimp using the approved crimping tool. Gently tug on wires to make sure they are secure before applying heat to them.
CAUTION: Do not use match or open flame to apply heat to seal.
6. Apply heat using Ultratorch or some other device, heating to 175 °C (347 °F) until glue flows around edges of sleeve.
IMPORTANT: The salmon splice can be used on the 0.35(22 gage) wire if the following additional steps are taken:
7. Remove 19 mm (3/4 in.) of insulation.
8. Bend the stripped portion in half to double the thickness.
9. Twist the stripped, doubled wire and insert into the splice sleeve.
Weather Pack Connectors
Weather Pack Connectors: Terminal Removal
TERMINAL REMOVAL
1. Remove any terminal position assurance (TPA) devices.
2. Insert the weather pack removal tool into the front of the terminal cavity.
CUT LEAD INSTALLATION
1. Put connector seal on wire and strip approximately 9.5 mm (3/8 in.) off the wire. Caution must be used to prevent cutting the wire strands.
2. Remove insulation from the end of the cut lead and the harness. Recommended strip length is 9.5 mm (3/8 in.). Caution must be used to
prevent cutting the wire strands.
