SW2 L4-1.9L DOHC VIN 7 (1997)
Lifter / Lash Adjuster: Service and Repair
Bleeding Lifters Following Service
CAUTION: After cylinder block, head or lifter replacement, it will be necessary to allow the engine to idle for three to five minutes. If lifters are noisy,
warm the engine up at a low rpm (less than 2000). After the coolant temperature has reached approximately 85° C (185° F), cycle the engine rpm from
idle to 3000 for approximately 10 minutes or drive the vehicle eight kilometers (five miles) to purge the air. If the air cannot be purged, the faulty
lifter(s) will have to be replaced.
