SW2 L4-1.9L DOHC VIN 7 (1997)
1. Position the bracket to the midrail.
2. Hand start all seven fasteners. (Four fasteners attach from engine side of bracket, and three fasteners attach from wheelhouse side of bracket.)
3. Tighten all fasteners.
-
Torque: 32 Nm (24 ft. lbs.)
NOTICE: If the engine mount front cover stud turns or comes out during nut removal, the stud must be fully installed prior to installing the
mount and/or nut. Damage to the front cover may occur if the stud is driven with the nut and does not sufficiently engage the front cover threads.
4. Position the engine mount to the front cover and install new nuts.
-
Torque: 50 Nm (37 ft. lbs.)
NOTICE: When lowering the powertrain, it will be necessary to guide the mount over the midrail bracket studs to prevent damage to the stud
threads.
