SW2 L4-1.9L DOHC VIN 7 (1997)
g. Install the fixed guide. Torque to 28 Nm (21 ft. lbs.).
CAUTION: The timing chain should be snug against the fixed guide.
h. Install the pivoting chain guide. Check for clearance between the block and head. Torque the bolt and make sure the guide pivots freely.
Torque to 26 Nm (19 ft. lbs.).
CAUTION: The camshafts must be positioned fully forward prior to bearing cap installation.
i.
Install the two forward remaining camshaft bearing caps and timing chain guide. Torque to 14 Nm (124 inch lbs.).
j.
Retract the tensioner plunger and pin the ratchet lever using a 3.18 mm (1/8 inch or No. 31) drill. Install the chain tension and torque the two
bolts. Remove the drill and allow the tensioner plunger to extend. Torque to 19 Nm (168 inch lbs.).
k. Verify all timing marks for accuracy. Remove the camshaft timing pins.
2. Camshaft timing verification procedure with engine assembled (front cover on):
a. Remove cam cover.
b. Turn the crankshaft clockwise until the mark on the damper pulley aligns with the pip mark on the front cover.
