SW2 L4-1.9L DOHC VIN 7 (1997)
Air Duct: Service and Repair
End Cap Assemblies
End Cap Assembly Removal and Installation
REMOVAL
1. Remove screws.
2. Carefully pull end cap assembly outward at clip locations.
INSTALLATION
1. Install end cap assembly by pushing in at clip locations.
2. Install and tighten screws.
Torque: 2.2 N.m (20 in-lbs)
End Cap Assembly Disassembly and Assembly
LEFT END CAP
DISASSEMBLY
1. Carefully remove duct from outlet housing.
2. Remove housing from end cap.
3. Remove vane assembly from housing.
ASSEMBLY
1. Install vane assembly to housing. Large pivot on bottom.
2. Install housing to end cap.
3. Install duct to housing.