SW2 L4-1.9L DOHC VIN 7 (1997)
2. Remove fasteners and pull radio/HVAC controller cover rearward.
3. Disconnect traction control/fog lamp/rear defog electrical connector, if equipped.
4. Rotate center deflectors down.
5. Place a small flat blade screwdriver between deflectors and pry slightly apart to disengage pivot point.
6. Remove deflectors.
7. Use a small flat blade screwdriver to disengage lock tabs on both sides of center outlet housing while pulling housing rearward.
8. Remove housing.
INSTALLATION
1. Install center outlet housing into opening in instrument panel retainer. Push in until tabs are flush with sides of housing.
2. Rotate center outlets down and snap into housing.
IMPORTANT: Small pivot pins are in center of housing. Large pivot pins are on sides of housing.
3. Connect traction control/fog lamp/rear defog electrical connector, if equipped.
4. Install radio/HVAC control cover. Push in at clip locations.
5. Install push pins and lock.
