SW2 L4-1.9L DOHC VIN 7 (1997)
6. Install clutch drive plate holder tool SA9510AC, and remove drive plate center bolt.
7. Remove drive plate holder tool and completely thread clutch drive plate remover sleeve SA9506AC into center of drive plate.
8. Thread drive plate remover bolt into sleeve. While holding clutch drive plate remover sleeve, tighten drive plate remover bolt to remove drive
plate.
IMPORTANT: Be careful not to lose the shims when removing drive plate from compressor shaft.
9. Using external snap ring pliers, remove the snap ring.
CAUTION: Do not remove pulley without puller adapter. If A/C compressor shaft is pressed on, A/C compressor will be damaged.
