SW2 L4-1.9L DOHC VIN 7 (1997)
5.
Insert nozzle tip of spray gun through the drilled hole and orient so spray pattern will be parallel to the evaporator face.
6.
Apply cooling coil coating using short bursts and rotating the nozzle tip up and down. This will allow for an even distribution and to ensure full
coverage of the evaporator.
7.
Allow evaporator core to soak for 30 minutes.
8.
Dry evaporator by:
^
Adjusting temperature to full hot
^
Turning RECIRC On
^
Making sure A/C button is Off
^
Open windows 1/2 in. and close doors
^
Start engine and allow to reach operating temperature
^
Allow blower motor to operate on HI blower for 5 minutes once engine reaches operating temperature
