SW2 L4-1.9L DOHC VIN 7 (1997)
carpet.
5.
From passenger side of vehicle, wipe clean top center horizontal surface of heater duct.
6.
Remove hook side of hook and loop retainer that is attached to delayed blower motor control module.
7.
Peel backing off of hook side of hook and loop retainer and apply to top center horizontal surface of heater duct between two structure ribs. Press
firmly to seat.
8.
Install edge clip on electrical connector of delayed blower motor control module.
9.
Using electrical tape, solid wrap delayed blower motor control module pigtail harness.
10.
Cut a piece of cardboard approximately the same size as the delayed blower motor control module and place it under the loop side of the hook and
loop material attached to the module.
11.
From driver's side of vehicle:
11.1 Insert delayed blower motor control module, with pigtail harness end first and hook and loop retainer down, onto the top center horizontal
surface of the heater duct.
11.2 Align delayed blower motor control module so that the rear edge is flush with heater duct edge on driver's side of vehicle.
11.3 Remove cardboard.
11.4 Press down on blower motor control module to engage hook and loop retainer. (Delayed blower motor control module should fit securely if
engagement of hook and loop retainer has been achieved.)
