SW2 L4-1.9L DOHC VIN 7 (1997)
4. Install heater core side cover and screw.
Torque
^
Screws1.7 Nm (15 lb in)
5. Push temperature cable over pin and snap temperature cable hold down clip over temperature cable holder.
6. Install heater duct by carefully sliding in sideways and up into position.
CAUTION: Take care not to damage rear floor heater duct seal.
7. Install screws and clips on lower heater duct.
Torque
^
Screws 1.7 Nm (15 lb in)