SW2 L4-1.9L DOHC VIN 7 (1997)
4. Install upper trim panel insulator
IMPORTANT: Make sure to tuck in all flaps.
IMPORTANT: Be sure upper trim panel seal is correctly seated on forward edge before installing upper trim panel.
5. Install upper trim panel into clips at base of windshield.
IMPORTANT: Be careful, when removing or replacing upper trim panel, not to damage VIN plate.
6. Lower panel, making sure upper trim panel alignment tabs interlock with windshield garnish slots.
7. Push down at clip locations to secure.
Upper Dash Trim Panel
8. Install and tighten screws.
9. Install screw caps.
-
Torque: 2.3 Nm (20 inch lbs.)
10. Install AIR BAG fuse to VP junction block.
11. Turn ignition switch to the RUN position and verily that the AIR BAG warning lamp flashes seven times and then turns Off. If it does not operate
as described, perform the "SIR Diagnostic System Check."
