SW2 L4-1.9L DOHC VIN 7 (1997)
Tachometer: Service and Repair
Installation
Speedometer Or Tachometer Installation
If tachometer was removed, begin with step 1 (tachometer must be installed before the speedometer can be installed). If only speedometer was removed,
start with step 3.
1. Align the tachometer over the two guide pins and press downward equally on both edges of the gage (at the top and bottom clips) until fully seated
(snaps).
2. Seat the indicator dial face onto retaining pins (two small white pegs up by the turn indicators.)
Speedometer Or Tachometer Installation
3. Align the speedometer over the two guide pins and press downward equally on both edges of the gage (at the top and bottom clips) until fully
seated (snaps).
4. Inspect and verify rest position of speedometer and tachometer pointers.
5. Clean dial faces with low volume clean dry air - (207 kPa [30 psi] maximum) with a side-to-side sweeping motion.
6. Clean inside of lens/mask assembly with low volume clean dry air (207 kPa 130 psi maximum) with a side-to-side sweeping motion.
Speedometer Or Tachometer Installation
7. Holding lens/mask assembly by the ends and face up, align reset knob with hole in lens.
8. Start lens/mask tabs into slots in housing and at the top of cluster seat two housing tabs into lens/mask slots.
9. Press down on top of lens/mask around edge to fully seat all clips.
