SW2 L4-1.9L DOHC VIN 7 (1997)
CAUTION: Brake fluid is corrosive to painted surfaces. Take care not to allow brake fluid to contact painted surfaces on vehicle.
CAUTION: Use only DOT 3 brake fluid from a clean, sealed container. Do not use any fluid from a container which is wet with water. Do not use DOT
5 silicone fluid.
1. Fill the master cylinder reservoir with brake fluid. Keep reservoir at least half full during bleeding procedure.
2. If the master cylinder is suspected of having air in its bore, it must be bled before proceeding to brake line bleeding.
a. Loosen left front brake line (front upper port) at master cylinder.
b. Allow brake fluid to flow from front master cylinder port.
c. Tighten left front brake line into master cylinder.
^
Torque to 32 Nm (24 ft. lbs.)
d. Loosen left front brake line at master cylinder 1/4 turn.
e. Depress brake pedal slowly until fluid is seen coming from the fitting.
f.
Once again, tighten left front brake line into master cylinder, while pedal is being depressed and slowly release pedal.
^
Torque to 32 Nm (24 ft. lbs.)
g. Repeat sequence until all air is removed from front (secondary) master cylinder bore.
h. Loosen right front brake line (rear upper port) at master cylinder.
i.
Allow brake fluid to flow from rear master cylinder port.
j.
Tighten right front brake line into master cylinder.
^
Torque to 32 Nm (24 ft. lbs.)
k. Loosen right front brake line at master cylinder 1/4 turn.
l.
Depress brake pedal slowly until fluid is seen coming from the fitting.
m. Once again, tighten right front brake line into master cylinder while pedal is being depressed and slowly release pedal.
^
Torque to 32 Nm (24 ft. lbs.)
n. Repeat sequence until all air is removed from rear (primary) master cylinder bore.
3. Bleed individual calipers and wheel cylinders.
NOTE: To assist in freeing entrapped air, tap lightly on caliper casting with a rubber mallet.
