SW2 L4-1.9L DOHC VIN 7 (1997)
Coolant Line/Hose: Service and Repair
Surge Tank to Pipe Hose
REMOVAL
1. Drain cooling system.
2. Remove heater return pipe from hold down clamps.
3. Remove heater return pipe-to-thermostat housing clamp and hose.
4. Remove clamp and hose from coolant surge tank.
5. Lift pipe and use hacksaw to cut crimp ring on coolant bottle hose.
CAUTION: Cut only deep enough to separate crimp ring. Take care not to cut pipe.
NOTE: When cutting crimp ring, cut at 30 degree angle to centerline of hose.
6. Use a flat head screwdriver to separate ring from hose.
7. Remove hose and ring from pipe.
INSTALLATION