SW2 L4-1.9L DOHC VIN 7 (1997)
11. Disconnect liquid line from receiver-dehydrator.
12. Lower vehicle.
13. Remove liquid line from hold down clamps, lift receiver-dehydrator end of liquid line clear of underhood junction block.
14. Lift and rotate TXV end of liquid line counter clockwise to remove from vehicle.
15. Remove pressure sensor from liquid line.
INSTALLATION
NOTICE: Use only R-12 Refrigerant oil (mineral) to lubricate O-rings. Use of R-134a (PAG) oil will cause premature corrosion of fitting joints.
1. Remove protective cover from liquid line switch port and lubricate O-ring.
2. Install pressure switch to liquid line and torque to specifications.
Torque: 5.5 N.m (49 in-lbs)
